I absolutely hate cleaning chicken water tubs. Almost everyday, I would have to dump out the tubs and wash them… wasting a lot of time and water. When I first saw these nipples, I had dreams of never washing a chicken waterer out, ever again. The nipples are a simple device and are simple to install. There are two types: screw-in and push-in. I have only used the screw-in model and I’m opposed to changing the things that work. So, feel free to use the push-in nipples. I’ll just stick with the screw-in.
First, decide how many nipples you wany to put in the bottom of the bucket. I usually use two or three per 5 gallon bucket. Then, drill 11/32″ holes where you want the nipples.
Now, for the hard part. Screw the nipples into the hole. Ok. So, it’s not hard. If you drill an 11/32″ hole, the threads on the nipple will seal into the plastic in the bottom of the bucket. No silicone or other sealant is required.
Just hang the bucket at a height appropriate for the size of your chickens. Training the chickens to the bucket is simple. I usually just tap each of the nipples to leave a droplet of water on the nipple. The chickens will notice it, peck it, and get another drop. Repeat. Then, the other chickens will learn from the smart one. Remember the chicken that takes the first drop. It is the smartest chicken you have… lol. It has never taken a new batch of chickens more than 30 minutes to figure it out. Usually, one will get it started in just a few minutes or so.
If you need to add a bucket heater for the winter, just drill a hole for the cord, in the bucket lid, and cut a slot to the hole, so that you can snap the cord in. The bucket lid will still prevent the chickens from pooping in the water, even if they roost on top of the waterer.
The nipples are available from Farmtek and at this writing, cost $2.49 ea.


Tell Concharty what you're thinking!....